![]() We can set up our own VPN server however this requires knowledge to do it right. We should connect our local machine to VPN then in other side we should connect our clients machine to VPN that will allow us to access to localhost by local IP address. ![]() In short: figure out how the service you're using defines network interface bind, and modify it to fit. For this scenario we should use VPN services. This will listen on all enabled interfaces, including loop back and others. ![]() There's also a catch all: 0.0.0.0, or :: in IPv6 parlance: bind any available interface. This will not be reachable from any other host, as it's bound to the loop back interface only. This is commonly used when you want something to only be available locally: you tell it to bind to 127.0.0.1, or ::1, which is the loop back address. Maybe you want Apache to listen to 203.0.113.1, and nginx on 203.0.113.2? If so, you can specify this in the config files. Windows, Darwin, Linux and all other modern operating systems supports this, and it essentially let's you specify on what interface you want to listen. Linux, like all other modern operating systems, has the concept of where you're listening. Your terminal should look like this: Press Ctrl+O followed by Enter to save. At the bottom of openssl.cnf add this: san subjectAltName DNS:localhost. I'd like to find a similar, simpler solution that forwards TCP traffic in a purely neutral way. Type sudo nano /etc/ssl/openssl.cnf and press enter. My macOS firewall is not turned on, so there is not a problem as far as I know with the particular port being actively blocked.Ī make-shift solution I have found is this: browser-sync start -proxy "localhost:4200" -no-open -no-ghost-mode -no-notify -no-snippet -no-ui -port 4200īrowser-sync, however, is specifically HTTP oriented, and tries to mess around with the contents which are served in many way, hence all of the -no-xxx flags I'm using. I'm not trying to have my app visible to the whole world, just my LAN. Yet when I look for a solution to this problem, all I turn up is tools like ngrok, which isn't what I want. If I'm testing an Angular app which runs on that app will not be seen at by other computers on my local network.Īll I want to do is expose the localhost port to my LAN, not to the rest of the world. On a Raspberry PI I have, whatever I run on, say, is automatically visible to other computers on my local network at or.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |